The Basic Design Principle Of The Veneer Stackers

    Veneer automatic stacking machine is veneer production veneer in the production line (peeling machine) the latest supporting equipment. The successful development of the equipment and put into production use, the end of China's veneer manufacturers veneer after the veneer to rely on the history of artificial stacking, greatly improving the production of our veneer scissors production line, the level of automation.Veneer Stackers

    1, the basic structure of the automatic stacking machine: veneer automatic stacker of the basic structure of the main part of the transmission, the frame part of the adsorption part of the pneumatic part of the board part and control system and other components. The1) conveying part. The conveying section is mainly composed of conveyor, conveyor belt and drive roller. Conveyor frame with steel welded structure, the overall rigidity, high strength, mainly used to support the conveyor belt and drive roller. The drive roller has one of the driving roller and the driven roller, and is mounted on both ends of the conveyor. The bearing roller ends are fixed to the conveyor frame with bolts. Conveyor belt with two upper and lower, above the transport belt 2, the following four conveyor belt, holding the board forward delivery. 2) frame part. The frame part is mainly composed of supporting legs, stringers, beams and connecting plates, mainly used to support the upper part of the adsorption. 3) Adsorption part. Mainly by the fan and suction cover and other components, used to be transported to the board above the specifications of the veneer from the conveyor belt. 4) Pneumatic section. Mainly by the cylinder, gas source three components, etc., for the gradient gradient adsorption plate unloading mechanism and the lifting platform to provide power to complete the scheduled action. 5) board part. Mainly by the scissors hydraulic lift and the center of the device, used to stack the specifications after cutting the board. 6) control system. Using programmable controller inverter touch screen operation terminal and so on. The humanized design of the control system has reached the design goal of fast processing and stable performance.Veneer Stackers

   When the conveyor belt to the front of the board to the front part of the board, only the upper conveyor belt without the bottom of the conveyor belt, then the conveyor belt above the vacuum adsorption device, relying on negative pressure to the veneer adsorption in the conveyor belt, continue to move forward Transport veneer. The adsorption part is through the fan to change the airflow inside the bellows, the bellows to form a negative pressure, to achieve the veneer in the transport process without sliding transmission. When the veneer is conveyed to the set photometric detection position, the board position information is sent to the PLC system. The control device sends out the command, and the lifting rod of the unloading plate is pushed down to move the veneer away from the conveyor belt. After the board is lifted on the platform, the system controls the cylinder action of the push plate and completes the board alignment. When the board on the riser stand is set to the set height, the system completes the board stack.Veneer Stackers